Yarn twisting consulting
Get the twist, tension and output right on the twisters you already own, for the yarn you actually have to run.
Problems this covers
- End breaks that climb as soon as spindle speed goes up
- Twist that varies from spindle to spindle or from the start of a package to the end
- Lively, snarling yarn after plying, or plied yarn that will not sit balanced
- A new fibre or blend that will not run on settings that worked for the last one
- Output well below what the machine should give at that twist
- Customer complaints about strength, elongation or appearance that trace back to twist
How the work runs
It starts with the yarn spec, the machine and what is going wrong. Photos, a short video of the fault and the current settings are usually enough for a first read, and plenty of problems are solved at that point over a call.
Where it needs eyes on the machine, Paul comes to site. That visit covers the feed packages, the yarn path from creel to take-up, tension at each stage, spindle and traveller condition, and the twist that is really going in compared with the twist on the setting sheet.
You get a short written report: what was found, the settings to change, the parts worth replacing, and what output to expect once it is done.
Yarns and constructions
Staple and continuous filament, singles and plied, in natural, synthetic and blended yarns. That includes cotton and polyester sewing and industrial threads, nylon and polypropylene twines, technical filament yarns and fancy constructions.
If your yarn is unusual, say so in the enquiry. Unusual is normally where the interesting work is.
Setting up a new product
Taking on a yarn you have not run before is where most of the cost hides: trial time, waste and a slow ramp to speed. Paul can work out a starting twist, the direction for each stage, tension and speed windows, and a trial plan that reaches a stable setting in as few runs as possible.
Tell Paul what the machine is doing
Send the yarn, the machine and the problem. You will get a straight answer on whether it can be fixed on the equipment you have, and what it would take.