YarnTwisting Twisting, winding and coating consulting

Twist multiplier calculator

Find the twist multiplier of a yarn, or the twist to set for a target multiplier.

Multiplier from count and twist

English multiplier (αe)
Metric multiplier (αm)
Tex twist factor

Twist from count and multiplier

Turns per inch
Turns per metre

What the twist multiplier tells you

Turns per inch on its own does not say how hard a yarn is twisted. Ten turns per inch is a lot for a heavy yarn and very little for a fine one. The twist multiplier removes count from the picture, so two yarns with the same multiplier have the same twist angle and a similar character, whatever their size.

αe = TPI ÷ √Ne    αm = TPM ÷ √Nm    Tex twist factor = turns per cm × √tex

The three are the same idea in different units: αm is about 30.3 × αe, and the tex twist factor is about 9.57 × αe.

Typical ranges for ring spun cotton

UseαeCharacter
Knitting3.0 to 3.5Soft, bulky
Weaving weft3.5 to 4.0Medium
Weaving warp4.0 to 4.5Strong, lean
Crepe and voile5.0 and overHard, lively

These are starting points, not rules. Fibre length, fineness and the job the yarn has to do all move the right answer. Continuous filament yarns need far less twist than staple yarns, because the twist is there to hold filaments together and protect them, not to create strength from friction.

Using it when you change count

When a customer asks for the same yarn in a different count, keep the multiplier and let the calculator give you the new twist. Keeping the same TPI across counts is the usual mistake, and it gives a finer yarn that is too soft or a heavier one that is too hard.

More calculators

Numbers right but the yarn still will not run?

The sums are the easy part. If the machine is not doing what the calculation says it should, Paul can help find out why.

Send an enquiry