YarnTwisting Twisting, winding and coating consulting

S twist and Z twist explained

Twist direction is a small detail that decides whether a plied yarn sits balanced and whether a thread survives a sewing machine.

What the letters mean

Every twisted yarn spirals one of two ways. Hold the yarn upright and look at the angle of the fibres or plies on its surface.

  • If they slope the same way as the middle stroke of the letter Z, rising from bottom left to top right, it is Z twist.
  • If they slope like the middle of the letter S, rising from bottom right to top left, it is S twist.
Z S
Left: Z twist, sloping the same way as the middle of a Z. Right: S twist, sloping like the middle of an S.

It does not matter which end is up. Turn the yarn over and the slope stays the same.

How to check in ten seconds

Hold the yarn upright next to an ordinary bolt or wood screw. A standard right hand thread slopes up to the right, the same as Z twist.

  • If the yarn slopes the same way as the screw thread, it is Z twist.
  • If it slopes the opposite way, it is S twist.

On fine yarns, use a magnifier and good light from the side. For a plied yarn, do this twice. First check the ply twist, then untwist the plies, pull out one single and check that.

Why singles and ply go in opposite directions

Twist stores torque. A singles yarn with twist in it wants to untwist, which is why it snarls back on itself when you let it go slack.

When two or more singles are plied together in the opposite direction, the ply twist takes out some of the torque in each single. At the right ply twist the two forces cancel and the yarn hangs straight in a loop. That is a balanced yarn.

So the usual constructions are:

Singles Ply Result
Z S The most common plied yarn
S Z Standard for most sewing threads
Z S, then Z Cabled yarn or cord, three stages

Plying in the same direction as the singles adds torque instead of removing it. It gives a hard, lively yarn that is only wanted for special effects.

Twist direction and sewing thread

On a lockstitch sewing machine, the hook and needle action rolls the thread in one direction. A Z twist finished thread is tightened by that action. An S twist finished thread is opened up, the plies separate, and it frays and breaks.

That is why nearly all sewing thread is finished with Z twist, built from S twist singles. If a thread runs well by hand but shreds on the machine, direction is the first thing to check.

Does direction change strength?

No. An S twist yarn and a Z twist yarn made the same way have the same strength and stretch. Direction matters because of what happens next:

  • Plying and cabling. Each stage has to go the right way against the one before.
  • The next machine. Some processes add or remove twist as the yarn runs, especially over end unwinding, which puts in or takes out one turn per wrap.
  • Fabric appearance. Light reflects differently off S and Z yarns. Mixing them by accident shows up as bars or stripes in the fabric.

Getting the direction right on the twister

On most twisters the direction is set by which way the spindle turns, and on many machines by how the drive tape or belt is run. After any change, check the first metre of yarn before the machine is left to run. A full doff twisted the wrong way cannot be fixed. It can only be untwisted and done again, at twice the cost.

Three habits prevent it:

  1. Write direction on the setting sheet next to every twist figure, for example 400 TPM Z.
  2. Keep S and Z singles in differently coloured tubes or marked crates.
  3. Check direction on the first package of every lot, not only after a machine change.

To convert the twist level itself, use the TPM to TPI converter. To work out how much twist a count needs, use the twist multiplier calculator.

Tell Paul what the machine is doing

Send the yarn, the machine and the problem. You will get a straight answer on whether it can be fixed on the equipment you have, and what it would take.

Send an enquiry